Unifoam

 Wetting Agents
Home

Products

 

More Info?

 

Bottom of Page

 

uniWET

uniWET is a general purpose wetting agent suitable for a variety applications where it is necessary to allow water or water solutions to "wet out" surfaces much faster than regular water.

Applications


1. Fire Fighting
uniWET reduces the surface tension of water to allow better and faster penetration of water in CLASS A materials. Only a small amount of uniWET is required, usually between 0.05% and  0.1% (or 1 litre of uniWET per 1000 litres of water). uniWET is superior than Class A foams when used as a wetting agent.

2. Industrial
uniWET produces a very low contact angle on surfaces (when compared to water), allowing better for better penetration and coverage.

uniWET is available in 4 litres plastic bottles. (packaged in 4 bottles per case)

This product is biodegradable, non-corrosive and poses minimum risk to the environment.

 

TYPICAL PROPERTIES
  Specific Gravity (20 C) 1.04 to 1.06
  pH (20 C) 7.5 to 8.5
  Viscosity (25 C) 15 to 25 cps
  Surface Tension (20º C) at 0.1% 28 mN/m
  Freezing Point -5º C
  Minimum Use Temperature -3º C
  Maximum Use Temperature 49º C
  Storage Temperature 0º C to 49º C
  Recommended Storage Stainless steel, fibreglass, polyethylene
Shipping Containers
Shipping Weight
case 4 X 4 litres plastic bottles
approx. 17 kg
   

 

Unifoam  Wetting Agents
Home Products  

More Info?

  Top of Page
Copyright © 2024 Unifoam Company Limited. All Rights Reserved.
Specifications subject to change.